Main Line Hydro Jetting in Montebello is the fastest way to clear a backed-up sewer main without digging up your yard. We run a high-pressure sewer jetter through the line, cut out roots and grease, then camera-verify the pipe before we pack up. If your drains are slow or sewage is rising in the shower, call (323) 328-8521 and we roll a truck today.
Main Line Hydro Jetting in Montebello is a drain cleaning method that pushes water through your sewer main at 3,000 to 4,000 PSI. A jetting nozzle with rear-facing ports pulls the hose forward while blasting the pipe wall clean, so grease, scale and roots travel to the city connection instead of packing tighter. Most residential mains here run 4 to 6 inches, and a full pass takes 45 to 90 minutes depending on how far the blockage sits from the cleanout.
Montebello's older housing stock means clay and cast iron mains that have been in the ground for decades. Tree roots find the joints, grease from kitchen sinks hardens on the walls, and scale narrows the pipe until one Thanksgiving dinner pushes it over the edge. That is why we get calls for main line jetting Montebello at 2 a.m. from Rio Walk and El Carmel. A camera inspection before and after tells you exactly what came out and what is left.
Every main line job comes with camera inspection, high-pressure jetting, root cutting if needed, and a written summary. We quote repairs separately if the camera shows damage, and you decide whether to move forward. No bundled add-ons you did not ask for.
We run a RIDGID or Spartan Tool camera down the main before jetting to locate the blockage and check pipe condition, then again after to confirm the line is clean. You watch the monitor with us and get the footage the same day.
A jetting nozzle sized to your pipe runs at 3,000 to 4,000 PSI, flushing grease, scale and debris all the way to the city connection. We work in stages so the debris does not pack tighter downstream. Most residential mains clear in one pass.
If the camera shows tree root intrusion, we run a rotary chain cutter first to open a channel, then jet the debris out. This is standard on Montebello Hills and Brighton Hills properties where mature trees sit near the lateral. No extra charge on most jobs.
After jetting, we run water through every fixture that was backing up to confirm the line is open. We rinse the cleanout area, replace the cap and leave the workspace as we found it. If anything still drains slow, we camera it again before we leave.
You get a one-page summary with pipe material, footage cleaned, blockage type and any spots worth watching. We recommend a jetting interval based on what we saw, usually 12 to 18 months for residential mains with a history of roots or grease.
You call (323) 328-8521 or book online. We ask what is backing up, where the cleanout is, and whether it is one fixture or the whole house. That tells us if it is a main line problem or a branch line. We give you a price range on the phone and a firm number once we see the cleanout.
Before any water goes in, we feed a sewer camera down the main to find the blockage, measure how far out it sits, and check the pipe material. Clay, cast iron, ABS and orangeburg all get different pressure settings. This step takes 15 to 25 minutes and saves pipe damage later.
If roots are present, we run a rotary chain cutter first to open a channel. Then the high-pressure sewer jetter goes in with a jetting nozzle sized to the pipe, usually at 3,000 to 4,000 PSI. We work the hose forward in stages, flushing debris to the city main, until the line runs free.
We pull the hose, re-run the camera, and show you the before-and-after on screen. If there is a crack, a bellied section or a root mass we could not fully clear, you will see it and we will tell you what it means. No guessing, no upsell.
We rinse the cleanout area, put the cap back, and test every fixture that was backing up. You get a written summary with pipe material, footage cleaned, and a recommended maintenance interval. Most Montebello mains do best on a 12 to 18 month jetting schedule.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Truck-mounted jetter with a pressure gauge and hose reel that pushes water at 3,000 to 4,000 PSI through the main. We dial pressure to the pipe material and condition, so clay and cast iron get a gentler pass than ABS.
The nozzle is sized to the pipe diameter and has rear-facing ports that pull the hose forward while blasting the wall. For roots, we swap to a rotary chain cutter that shaves the root mass back to the pipe wall before jetting the debris out.
A camera on a reel of sewer camera cable goes down the main to locate the blockage, measure distance to the city connection, and record pipe condition. We use it before and after every jetting job and send you the footage.
The hose has to hold 4,000 PSI daily without kinking or bursting. We run Gorlitz hose on our reels because it handles the pressure and the heat, and we inspect it after every job so a worn hose never becomes a call-back.
When the camera shows a small crack or a pitted section that does not need full replacement, we can apply a pipe patch to seal it. Descaling heads remove mineral buildup on cast iron and galvanized lines so jetting gets back to bare pipe.
A homeowner on a hillside lot had sewage backing into the shower every three months. Snaking cleared it for a few weeks each time. The camera showed a root mass at 42 feet and a second intrusion near 60 feet, with the pipe narrowed to about half its diameter.
We cut both root masses with a rotary chain cutter, jetted the line at 3,000 PSI, and camera-verified a clean pipe wall. Flow returned to full diameter and the homeowner has had no backup in 14 months.
A Whittier Blvd restaurant had a grease line backing up into the kitchen on Friday nights. The camera showed a 4-inch line reduced to about 2 inches by hardened grease and scale, with debris packed at the city connection.
We jetted at 4,000 PSI in staged passes, then ran a descaling head to remove the mineral layer. The line came back to near-full diameter, and the restaurant has not lost a dinner service since.
A family in Montebello Estates had slow drains in two bathrooms and the kitchen for months. No single fixture was fully blocked, so they put it off. The camera showed grease and scale buildup along 50 feet of cast iron main, with a partial blockage near the city connection.
One jetting pass at 3,500 PSI cleared the buildup and restored full flow at every fixture. The camera after showed bare pipe wall. Total job time was about two and a half hours.
Most main line calls fall into a handful of categories. Knowing which one you have tells you what the fix looks like and how long it will last.
Ask a pro →We cut the roots with a rotary chain cutter, jet the debris to the city main, and camera the pipe to confirm the roots are back to the wall. Most Montebello Hills and Brighton Hills properties get 12 to 24 months of clear flow from one pass.
High-pressure jetting at 3,000 to 4,000 PSI scrubs the wall back to bare pipe. On cast iron with heavy scale, we follow with pipe descaling to remove the mineral layer. Flow returns to near-new and stays there with a yearly maintenance jetting.
Jetting cleans the full diameter of the pipe, not just a channel. We camera before and after so you can see the difference. If the line keeps clogging after a full jetting, the camera usually shows a belly, offset joint or crack that needs a repair quote.
Call (323) 328-8521 and we dispatch for emergency main line jetting Montebello. We open the line first to stop the backup, then camera it to find the cause. Most emergency calls inside 90640 are cleared the same visit.
$285 - $850 depending on scope
Typical 2026 pricing for main line jetting Montebello runs $285 to $650 for a residential main, and $450 to $850 for commercial grease lines. The price depends on access, pipe length, blockage type and whether root cutting is needed. We quote a range on the phone and a firm number before we start. Camera inspection is included, and if the camera shows damage that changes the job, we stop and talk to you first. No hourly meter, no surprise add-ons.
A jetting job costs a fraction of excavation and pipe replacement, and it buys you 12 to 24 months of clear flow on most Montebello mains. Camera documentation means you know exactly what you paid for and what condition your pipe is in.
A main that runs 30 feet from the cleanout is faster to jet than one that runs 80 feet to the city connection. Cleanout location matters too. If the only access is under a crawlspace or behind a finished wall, setup takes longer and the price reflects it.
Grease and scale jet out in one pass. Roots need a rotary chain cutter first, which adds 20 to 40 minutes and a bit more cost. Heavy root jobs with multiple intrusions may need two passes, and we quote that upfront after the camera run.
Clay and cast iron get lower pressure and sometimes a gentler nozzle, which can take longer than ABS. If the camera shows a crack, a belly or an offset joint, jetting may not be the right fix and we will tell you before you spend money on a cleaning that will not hold.
Standard weekday rates apply to most jobs. Nights, weekends and holidays carry an emergency rate, which we quote before dispatch. If you can wait until morning, you will usually pay less, but a sewage backup is not something most people can sit on.
“Roots from the ficus in my front yard had been creeping into the main for years. Two other companies just snaked it and the backup came back in a month. These guys cut the roots, jetted the line and showed me the camera footage after. That was last spring and it has not backed up since.”
Maria G.Homeowner, Montebello Hills
✓ Verified“We manage a four-unit building near the Civic Center and the main backs up every winter. They set us up on a yearly jetting schedule and now we do not get the 2 a.m. calls. They show up when they say, they send the camera video, and the invoice matches the quote.”
Daniel R.Property Manager, Downtown Montebello
✓ Verified“Our grease line was backing up into the kitchen on a Friday night. They came out within the hour, jetted the line and had us open for dinner service. Now they do our grease line on a quarterly schedule and we have not had a backup in over a year.”
Tony V.Restaurant Owner, Whittier Blvd
✓ VerifiedMost residential main line jobs in Montebello run $285 to $650 in 2026, depending on access, pipe length and how much root cutting is needed. Commercial grease lines and long runs to the city main can reach $850 or more. Emergency and after-hours calls carry a higher rate, quoted before we dispatch. Camera inspection is included in that price.
Main line jetting is high-pressure water cleaning of the sewer main, the pipe that carries everything from your house to the city connection. A jetting nozzle on the end of a high-pressure hose blasts the pipe wall at 3,000 to 4,000 PSI, flushing grease, scale and roots out. It cleans the full diameter of the pipe, not just a hole through the clog.
Yes. Jetting clears grease, scale, roots and debris in clay, cast iron and ABS mains, and it is the standard fix for main line jetting for sewer backup Montebello calls. If the pipe is collapsed, bellied or badly cracked, jetting will not fix that and the camera will show it. In those cases we tell you what repair is needed instead of charging for a cleaning that will not hold.
It is safe when the pressure is matched to the pipe's condition. We camera the line first and dial the jetter down for older clay and cast iron, often running 2,000 to 3,000 PSI instead of 4,000. Clay pipe in good shape handles jetting fine. If the camera shows thin walls or offset joints, we adjust or recommend a gentler method.
Sewer Line Hydro JettingThe same high-pressure cleaning we use on the main, run from the city side or a downstream cleanout. Useful when the blockage sits past your property line or when the main has already been jetted and the lateral still runs slow.Explore →
Kitchen Drain Hydro JettingGrease and food solids from the kitchen sink are the number one cause of branch line clogs that feed into the main. We jet the kitchen line first so the debris does not get pushed into the main during a full-house cleaning.Explore →
Grease Line JettingRestaurants in Downtown Montebello and along Whittier Blvd run grease lines that need scheduled jetting, not emergency calls. We set up a maintenance interval so the line never reaches the point of backing up into the kitchen.Explore →
Restaurant & Commercial Hydro JettingCommercial kitchens, laundries and multi-unit buildings need larger jetters and off-hours scheduling. We run night work so your business does not lose a day, and we document every pass for your grease trap and health inspection records.Explore →
Tree Root Removal by Hydro JettingRoots are the top cause of main line blockages in Montebello Hills and Brighton Hills. We cut them with a rotary chain cutter, flush the debris, then camera the pipe to confirm the roots are back to the wall and not still intruding.Explore →
Pipe DescalingScale and mineral deposits build up on cast iron and galvanized mains, narrowing the pipe year after year. Descaling removes that layer so the pipe flows like it did when it was new, and it pairs well with jetting on the same visit.Explore →
Camera Inspection Before & After JettingEvery main line job includes camera work on both ends. Before tells us what we are dealing with and sets the pressure. After proves the line is clean and shows any damage that needs a repair quote.Explore →
Floor Drain & Storm Drain JettingFloor drains in garages and commercial bays clog with silt and debris, and storm drains back up after heavy rain. We jet those lines with the same equipment, which keeps water moving away from your foundation and out of the building.Explore →Sewage backing up is a now problem. Call (323) 328-8521 and we will dispatch a jetter truck with a camera on board. Licensed, insured and bonded, with upfront pricing before we start. If your main is slow or already backing up, do not wait for it to get worse.
Book Jetting Now (323) 328-8521 →Reach us at (323) 328-8521 any time, day or night. For routine jetting we answer between 8:00 and 18:00 Monday through Friday, and emergencies get a live person around the clock. Tell us what is backing up and where, and we will give you a price range and a service window on the spot.